LUISO® W45

LUISO® W45

for Vacuum Carburising

  • without solvents

  • environment friendly and copper-free

  • viscosity and course may be adjusted by water

  • drying time appr. 30 minutes only

  • good protection properties

 


Properties:

LUISIO W45 is a ragrance-free and solvent-free stop off paint for gas carburizing. It provides good protection properties against carbon depths up to max. 1,5 mm. The stop off paint is delivered ready for painting.

 

Preparation:

The work pieces to be treated must be free of grease and dirt!

 

Application:

Before using, LUISO W45 should be stired up shortly and then applied with a paint brush. One layer is sufficiant. To avoid evaporation the cans should be sealed hermetically after use. To restore normal viscositiy the stop off paint can be diluted by adding up to 2 % water. No special thinners are necessary. The dry off time for LUISO W45 is 30 minutes. Unwanted paste residues may be removed easily with water. The heat treatment with LUISO W44 should not exceed temperatures above 1050 °C. After heat treatment the LUISO W45 residues can be removed by shot-blasting or steel brushing.

 

Packing:

LUISO W45 to be delivered in PP-cans of 1, 5 or 10 kg.

 

Storage:

LUISO W45 is sensitive to frost. Storage at room temperature is recommended. Opened cans should be closed after use. Storage time should not exceed 12 months.

 

Free Sample:

Here you can order a free sample -click here-

 

Contact

DAM Härtetechnik GmbH
Am Bubenpfad 2
D-67065 Ludwigshafen

Phone: +49 (0)621/4549666
Telefax: +49 (0)621/4549667

E-Mail: This email address is being protected from spambots. You need JavaScript enabled to view it.